| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Drill Bits http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=8880 |
Page 1 of 1 |
| Author: | Brock Poling [ Mon Oct 16, 2006 4:30 am ] |
| Post subject: | |
I am looking for a few hard to find sizes of drill bits. In a perfect world a high quality forstner bit would be perfect.. but I am striking out so any flat bottomed bit would probably work. 37/64" 19/32" 39/64" If you know where I could get some that would be great. Thanks. |
|
| Author: | tippie53 [ Mon Oct 16, 2006 4:36 am ] |
| Post subject: | |
Look for center cut end mills if you can't find drill bits. MSC or any machinst supply with carry both the drill bit and the mill cutter john hall |
|
| Author: | Brock Poling [ Mon Oct 16, 2006 11:51 am ] |
| Post subject: | |
I ended up finding some brad point bits at www.preferred-drillbits.com I was hoping for forstners, but these will work ok. |
|
| Author: | old man [ Mon Oct 16, 2006 1:12 pm ] |
| Post subject: | |
Brock, I bet you could buy some slightly oversized forstners and have a machine shop turn them down to the size needed and resharpen them. Ron |
|
| Author: | Keith M [ Mon Oct 16, 2006 1:30 pm ] |
| Post subject: | |
You might try these guys they claim to have all sizes and also custom make drill bits to order. http://www.advantage-drillbits.com/ |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|